Browse other related Products
MS® Glass Solvent Filters
Introduction
All-glass design restricts contact with reactive surfaces such as steel or rubber to minimize contamination of sample or filtrate.
Standard 47/50mm filtration funnels mount on filtration flask using a ground glass joint.
Outlet of support base drip tube is positioned below the side arm connection to prevent sample aspiration into vacuum line.
All wetted surfaces are borosilicate glass with the exception of stainless steel and PTFE support options.
This product is made of high-quality extra hard glass.
It is sparking and crystal-clear. Its thickness is even.
The performance of withstanding voltage and its leakproofness is very good. Its size agrees with the international standard size.
It can be used for sterilization at high temperature and high pressure.
PDF [
1 Page / 169k ]
Specifications
| Materials: |
| Funnel, base unit and flask |
Borosilicate glass |
| Support |
Borosilicate glass frit, stainless steel, or PTFE |
| Connection: |
| Ground glass joint |
14/20 female, 40/35 female |
| Side arm |
6 mm (3/8 inch), 6 mm (3/8 inch) |
| Capacity: |
| Funnel |
300ml, 500ml |
| Receiver flask |
1000ml, 2000ml |
| Suitable Membrane |
φ47 orφ50, φ60 |
Application
Glass Vacuum Filter aqueous, organic or corrosive liquids for particulate contamination analysis
It is recommended for HPLC solvent filtration and it has the function of outgas to guarantee the clean of mobile phase and avoid the blockage of HPLC liquid flow path.
