Cap-SL Capsule Filter

Description

Cap-SL series filter cartridges are designed specifically for high viscosity slurry filtration in the lithium battery industry, with a pure PP shell and good chemical compatibility. At the same time, the capsule design can effectively prevent material leakage when replacing the filter cartridge, effectively reduce the cost of customers, reduce material waste, and reduce direct contact with fluids by operators, thus effectively protecting the operator and the working environment. It can be matched with different sizes of built-in filter cartridge, with a length of 5 ", 10", 20 "optional, corresponding to different flow requirements. Among them, the C2SL series is an capsule filter designed specifically for ultra high flow, which can adapt to high-speed coating production lines. It has a built-in 7-core filter cartridge, with a large capacity design, greatly extending the service life of a single filter cartridge and reducing the replacement frequency, and a bottom drain design, which can be used for recycling customer fluids.

Features & Advantages

Avoiding pollution:

Installed inside the stainless steel housing to isolate the contact between the stainless steel housing and the material liquid, avoiding the leakage of the material liquid when replacing the filter cartridge, and reducing environmental pollution to the material liquid production environment.

Low material liquid loss

Compact structure design, with the filter cartridge tightly attached to the shell, reduces the residue of the material liquid, effectively reducing the waste of the material liquid, and saving costs for users.

Multiple specification selection

According to the actual needs of production process, filter cartridges with different specifications & sizes, and removal ratings can be selected to meet the needs of different applications for different filtration flows and different filtration efficiency.

Easy installation and operation

The capsule structure simplifies the operation of filter cartridge replacement, shortens the replacement time, and eliminates the need to clean the filter after replacement, greatly reducing the manual operation time and cost.

Typical Applications

Magnetic pulps
Battery slurry
Chemical paint and ink
Coating materials for digital images
MLCC Slurry Filtration

Technical Parameters

Product Type		C1SL	C2SL
Material Structure	Filter Media	PP
	Capsule material	PP
	O-Ring material	EPDM/Silicone/NBR/FKM
	Removal Ratings	30μm、50μm、75μm、100μm、150μm、200μm
Dimensions	Max. O.D. of capsule(mm)	Φ87	Φ248
	Total length of capsule(inch)	5"/ 10" / 20"	10"
	No. of built-in filters	1pc	7pc
Operating Conditions	Max. operating differential pressure	3.0bar@25℃
	Max. operating temperature	60°C

Dimensional Drawing

Ordering Information

Product	Length	Pore Size	Sealing Material
C1SL	005=5" 010=10" 020=20"	H30=30μm H50=50μm H75=75μm T10=100μm T15=150μm T20=200μm	S = Silicone E = EPDM F = FKM N = NBR
C2SL	010=10"	H30=30μm H50=50μm H75=75μm T10=100μm T15=150μm T20=200μm	S = Silicone E = EPDM F = FKM N = NBR