MS® Submerged PTFE Flat Sheet MBR Module
MS submerged PTFE flat sheet membrane module configuration comprises an element block and an aeration block. The element block contains a number of membrane elements stacked at equal intervals, each of which has flat sheet membranes attached on both sides of a supporting panel. Each element is connected via a tube to a permeated water manifold. The aeration block consists of air diffusers used to supply air.
MS self-research and develop the PTFE flat sheet membrane, manufacture the submerged MBR module, design and assembly the MBR package or MBR system for clients’ any needs.
Features
- PTFE flat sheet membrane materials have the unique properties of extremely hydrophilic, strong chemical resistance and longer service life
- Higher permeate water quality than national discharge water standard
- Easy to clean, and longer period between chemical cleaning
- Lower energy consumption and smaller footprint
- Lower sludge production and lower the cost of sludge disposal
Applications
- High turbidity water treatment (Industrial water or municipal wastewater)
- Food & Beverage waste water treatment
- Landfill Leachate
- Pharmaceuticals waste water
- Separation of Biochemical Products and Fermentation Products
- Purification of Condiment & Beverage
Specifications of PTFE Flat sheet Membrane Elements
| Membrane Elements Type | MSMBR150 | MSMBR090 | MSMBR028 |
| Active Membrane Area(m²） | 1.5 | 0.9 | 0.28 |
| Flux(L/Pc·Day) | 540-900 | 320-540 | 100-160 |
| Pore Size(μm） | 0.1 | ||
| Membrane Material | PTFE | ||
| Backing Material | ABS | ||
| Dimension（mm） | 510×1630×7 | 510×1010×7 | 310×510×7 |
| Weight(kg) | 4.5 | 0.9 | 0.3 |
| MLSS(mg/L) | 8000-18000 | ||
| Turbidity of Effluent | ＜1.0 | ||
| Suspension of Effluent(mg/L) | ＜1.0 | ||
| Transmembrane Pressure(kpa) | 5-20 | ||
| Optimum PH Range | 3-12 | ||
| Operating Temperature(℃） | 5-40 | ||
| Framework Material | 304# Stainless Steel | ||
| Aerator Pipe Material | 304# Stainless Steel | ||
| Port of Aerator Pipe | DN50 | ||
| Port of Collector Pipe | Active Interface | ||
| Collector Pipe Material | UPVC | ||
| Port of Collector Pipe | DN32 | ||
- The flux of one piece of PTFE membrane is tested in vacuum condition at 25℃.
- Aeration rate is determined by MBR size and effluent condtion.
