
MS® PlatPure Cartridge Filter
Request a QuoteDescription
MS® PlatPure has been designed for ease of use whilst increasing productivity when compared to conventional filter formats. PlatPure is 100% thermally welded in its construction and can also be supplied in a high temperature version. Combining 6.25 inch OD design with the technique of pleating several different filter media together in a single pleat pack maximizes dirt holding capacity and filter area. Available in a wide variety of filter media, this cartridge can be constructed with metal end caps and core for high temperature applications.
Features
- Fully thermally welded, no glue or adhesives
- Large diameter yields higher flow rates
- High flow capacity permits use of fewer elements and cuts capital expenditure
- Positive o-ring seal assures filtration integrity
- Wide chemical compatibility
Applications
- Prefiltration of RO, Pretreatment of sea water desalination
- Condensed water treatment for power plant
- The filtration of bottled water, soft drinks and other beverage
- Microeletronics process water
- Surface water intake
- Waste water filtration
Specification
Materials of Construction:
- Filter Medium: Pleated Polypropylene, Pleated Glass Fiber
- Support/Drainage: Polypropylene/Polyester net
- Inner Core: Polypropylene
- End caps: Glass fiber reinforced polypropylene
- O-ring Seal Material: 226 O-ring /EPDM, NBR, Viton
Dimensions:
- Outside Diameter: 6.25” (159mm)
- Length: 30” (749mm), 40” (962mm)
Recommended Operating Conditions:
- Maximum Temperature: Pleated Polypropylene: 82℃
Pleated Glass Fiber: 121℃
- Maximum Pressure: Pleated Polypropylene: 2.5 bar@82℃
Pleated Glass Fiber: 2.5 bar@121℃
- Micron Rating: 1~70μm
- Filtration Area: 6.0㎡/40”
Ordering Information
More Cartridge Filter Main Page >>
600 FlowPure® Cartridge Filter