FluorPure-E PTFE Filters

Request a Quote

Introduction

MS®FluorPure-E PTFE filters using expanded PTFE membranes along with high density polyethylene (HDPE) support and components can be specifically recommended for bulk filtration of photo resists and chemicals which are compatible with PTFE and HDPE. In addition, HDPE components lower metallic/ionic contamination than PP materials that provide a higher purity guarantee, reduce particle contamination with superior downstream cleanliness.

FluorPure-E PTFE Filters

Features

  • Wide range of configurations
  • High flow rates and low pressure drop
  • Low extractables
  • Manufactured in a clean room environment
  • 100% integrity tested

Applications

  • Photo resist
  • High cleanliness chemicals
  • Solvent-based chemicals
  • High-viscosity fluids

Specifications

Materials of Construction
Filter Medium Expanded PTFE (polytetrafluoroethylene)
Support and drainage HDPE (High density polyethylene)
Inner support core
Outer protection cage
End caps
O-Rings EPDM, FEP Encapsulated fluoroelastomer
Recommended Operating Conditions
Maximum Temperature 140℉ (60℃)
Maximum Pressure 58psi (4bar)@ 70℉ (21℃)
Particle Removal Ratings(Nominal, μm) 0.03, 0.05, 0.1, 0.22, 0.45, 1.0
Effective Filtration Area (10inch)
0.2-1μm

0.8m² (8.6ft² )

0.1μm 0.88m² (9.5ft²)
0.03-0.05μm 0.95m² (10.2ft²)

Pressure Drop vs. Liquid Flow Rate

PTFE Cartridge Filter

Ordering Information

USA China Japan
Toll Free: 1-866-528-4572
Fax: 1-732-412-4040
Toll Free: 400-820-0293
Fax: 86-21-51687551
Toll Free: 81-3-6434-9902

Related Products