KynarPure®-L using high porosity, hydrophilic PVDF membrane, the structure of the reasonable configuration, make full use of the advantages of high velocity of PVDF membrane, and can improve the filter dirt holding capacity, prolong service life. KynarPure®-L filters are especially suitable for application in the bulk material filtration, can provide better performance compared to similar products, while ensuring low cost.
KynarPure®-L PVDF Cartridge Filter
Materials of Construction |
||
---|---|---|
Media |
Polyvinylidene fluoride |
|
Support/drainage |
Polypropylene |
|
Cage/End Caps |
||
Core |
Polypropylene/Polysulfone |
|
Adapter |
Polupropylene with stainless steel inner /Polypropylene |
|
O-Rings/Gaskets |
Silicone/EPDM |
|
Operating Conditions |
||
Maximum operating temperature |
1.7Bar@82℃ |
|
Maximum Forward Differential Pressure |
5.2Bar@25℃ |
|
Maximum Reverse Differential Pressure |
2.1Bar@25℃ |
|
Recommended change-out pressure |
2.4Bar |
|
Dimension |
||
Outside/Inner diameter |
68.5mm/33.0mm |
|
Lengths |
5″,10″, 20″, 30″, 40″ |
|
Effective Filter Area |
0.62m² per 254mm (10inch) |
|
Sterilization |
||
Autoclave |
30 x 30min @124℃ |
|
Steam In-Place (forward, 0.5bar) |
30 x 30min @124℃; 20 x 30min @134℃ |
Unit conversion: 1bar=100kpa
Flow rate is for a 25.4cm (10inch), cartridge. For liquids other than water, multiply differential pressure by fluid viscosity (cP)
The Flow Rate of KynarPure®-L 0.2um Compared with the Competitive Product
Example: CRPVDFL0100206SS |
|||||
Filter Media |
Length |
Pore Size |
Adaptor |
Sealing |
Core |
CRPVDFL: Hydrophilic Polyvinylidene fluoride |
005 = 5 inch 010 = 10 inch 020 = 20 inch 030 = 30 inch 040 = 40 inch |
020 = 0.22μm 040 = 0.45μm 065 = 0.65μm 100 = 1.0μm |
0 = DOE 2 = 222/Flat 3 = 222/Fin 6 = 226/Fin 7 = 226/Flat |
S = Silicon E = EPDM |
Blank = PP S = stainless steel P = Polysulfone |